$15.20
Need to add details to your foam armour?
Lumin's Workship has the answer for you! The foam clay starts out as a foamy, putty-like clay that stretches and blends back into itself beautifully.
Once the surface starts drying, it may become hard to smooth lines out, so a TINY bit of water is recommended. Once your piece is finished, leave it to air dry – the bigger the piece, the longer it will take*.
Once fully cured, the foam clay dries into a high density foam which can be cut, sanded, heat formed and glued to your your costume. The cured foam clay pieces do not need to be heat sealed but priming is recommended before painting!
*Lumin's recommends giving it around 48 hours to cure before painting, if your piece is large, the centre may not be fully cured yet. This is normal and you can prime and paint your piece before it's cured on the inside! But you must wait for your piece to be fully cured before cutting and sanding through the surface layer.
Share this great product and savings with others. Note: You and your friend's email addresses are only used once for this recommendation. We do not collect nor store the email addresses.
There Are No Reviews Yet. Share your thoughts with others and give your review